Benefits provided by the ESI Mold Max - Green Sand Optimizer:

1. Aeration of the sand at the point of fill to overcome pre-compaction effects in the sand transportation system.
2. Break up of sand lumps to provide uniform density of the sand delivered to the flask thus decreasing soft areas or voids in the mold.
3. Capability to control fill rate via variation in speed and direction of rotation of the aerator shafts.
   
4. Independent control of speed and direction of each shaft to assist in the direction of sand into hard to fill areas on the pattern or in the flask.
5. Reduced burn in caused by loose sand and soft areas of the mold.
   
6. Improved mold uniformity and density thus increasing heat absorption rate from castings.
   
7. Higher sand flowability
   
8. Less bond additions needed for same mold strength level.
   
9. Excess "free" moisture expelled during aeration.